Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
If this building is in a different IP subnet than the one the Exchange server is located, then you MUST configure the router/MSFC with "ip helper address" command.this is required for the Netbios session connectivity along with RPC connectivity. chec...
Hi,You must have a static valid IP address for the DB server at NOC(thats 10.10.100.100), then Your packet translations should happen this way:source:192.168.100.1 -> natted source:208.56.72.243 ->FR Internet -> destined for the valid IP for 10.10.10...
hey,NO NO, cable does matter ...is the router 3640???, until you attach the cable to the interface, sh run will show clockrate xxx depending on the serial port type(1500 for serial and 2048 for HSSI)attach the cable and do a sh run, you will immed se...
Hi,As an alternative, you can deny the Eigrp broadcast traffic in the dialer list(interseting traffic which triggers a call on the BRI) and permit all the other ip traffic.hope that helps,Daipayan
