About h.infotronique1

h.infotronique1 · 07-17-2019

Hello,i have create some commands profile to limits my helpdesk users but it didn't work :i want to give him access and manipulate all interfaces of my cisco switch and deny him access to the interface g1/2.here is the command i do on ise TACACS Com...

h.infotronique1 · 08-27-2017

I have ASA 5512x Base licence with Firepower i want to make upgrade of his licence and purchase a second ASA 5512x SEc-Plus without Firpeower to make a failover is that possible and how i configure it?thank you.

h.infotronique1 · 02-28-2017

Hello, I want to make my network destribute VLAN dynamicly i have NPS of microsoft and i make configuration in my switchs (Cisco) and it work fine now i have some IP PHONES (Grandstream) in my network that should connecte but i don't want to authenti...

h.infotronique1 · 01-16-2017

Hi; i want to re-image my module SFR; i have asasfr-5500x-boot-5.4.0-763 in an ASA 5512-x ( Version 9.2(2)4 ) the module SFR is up now and i activate a licence for URL feltring and AMP and IPS, if i do re-image him to asasfr-5500x-boot-6.0.0-1005; d...

h.infotronique1 · 01-12-2017

Hi everyone, I want to update my module SFR 5.4.0-764 to sfr 6.0.0-1005 my questions are: - can i do it from Virtual denfece centre management or i shall do it with ASA CLI and boot from the image? - if i do the update my licences that i have ""URL f...

h.infotronique1 · 07-21-2019

Hi Marvin,I thank you very match that was very helpfull, it was that command missed on my configuration and now it work fine.just for the rule on ISE, for me i did Deny alwys interface Gigabitethernet 1/2 not Gigabitethernet 1 2 like you did!!? thank...

h.infotronique1 · 07-18-2019

Hi Marvin,thak you for your reply,on the switch i activate the debug of aaa authentication and authorisation to see what happen and i have this when i type for exemple shutdown and no shutdown :6d23h: AAA/AUTHOR/TAC+: (1016080000): send AV service=sh...

h.infotronique1 · 08-29-2017

Hi,I know that I bothers you with my questions but I need to be sur before I purchase any thing, so if I buy the same one as that I have than should I purchase the licence for URL filtring and IPS and AMP ?thank you very much for your help

h.infotronique1 · 08-28-2017

Exactly i use firepower but i dont want activatite on the second ASA i want the failover for ASA not Firepower, is that possible ?thank you.

h.infotronique1 · 08-28-2017

Hi,Tahnk you Mr Francesco Molino .

Member Since	‎11-24-2016 02:30 AM
Date Last Visited	‎07-29-2020 12:06 AM
Posts	23

User Statistics

User Activity

ISE Device Administration (TACACS+)

ASA 5512x Failover with 5512x with firepower

DOT1X and IP Phones

module SFR 5.4.0

Update the module SFR 5.4.0 - 764

Re: ISE Device Administration (TACACS+)

Re: ISE Device Administration (TACACS+)

Re: ASA 5512x Failover with 5512x with firepower

Re: ASA 5512x Failover with 5512x with firepower

Re: ASA 5512x Failover with 5512x with firepower