Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Everybody,I was trying to configure EIGRP named mode for my routers by EIGRP Classic to Named Mode Conversion, But it is also it's not supported for my ios which appear below:
R1#show version
Cisco IOS Software, 7200 Software (C7200-ADVIPS...
Hello,
I want to disscuss here cisco WS-C4507R+E with (cat4500e-UNIVERSAL-M), Version 03.02.00.XO RELEASE SOFTWARECPU utilization, the output of #show processes cpu illustrated below:
#show processes cpu
Core 0: CPU utilization for five seconds: 7%;...
yes Julio im totally agree with you...But what if this access switch port connected to ESXI then it will advise the port fast feature to release the learning listening time and go to forwording state directly. but when it is connected to ESXI then it...
Hello,Ok then, at first i will run my IOS upgrading process. if the issue with snmp is still then i will deeply troubleshoot snmp issue with considering connectivity problem probability.I will post the final results here.Thanks for your efforts, it...
Hello,
thanks for your help again the output of "show processes cpu detailed process iosd" shown bellow:
C4507#show processes cpu detailed process iosd
Core 0: CPU utilization for five seconds: 5%; one minute: 5%; five minutes: 6%
Core 1: CPU utili...
Hi brselzer,
At first i want to thank you for your response sir,
i'm going to upgrade the software as you said even its not the cause of this issue. But after determine what exactly cause this problem with SNMP.the output that you required fo showing...
you can use the following command at least to know how many time is rested:
show int dialer 0 | section interface resets
it's give you the times that interface goes down and come up again.
and output will be like that:
0 output errors, 0 collisi...
