Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
Need your help. I have Active/Standby ASAs in my data center that is participating in OSPF. Question is we have to test failover between HA. From what I read people are having anywhere between 5-10sec outage during failover because of OSPF ...
Hello All, Im trying to use route-map using next hop. For some reason I am not getting any matching packets. SDM is setup for desktop routing. I am not getting any matches on my route-map nor my ACL.Code is 12.2(55)SE5 Configinterface Vlan11 descript...
Yes it is configure for stateful failover. I think failover to standby is fine is just rebuilding OSPF on the standby unit which has me concerned. Anyway to make it so we have no downtime or minimal at the least?
Question just to reassure myself. I dont need an ip any any at the end of my acl to allow regular traffic if I am reading this correctly. My route-map would only look for matching ACL any traffic that does not match would take the normal path correct...
