Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,this might be a stupid question but i'm unable to find the answer anywhere.I've used the wizard to setup ipsec vpn, i enabled the outside interface for ipsec access and went through the wizard setting address pools etc. When i try to connect with ...
Hi,i'm currently replacing my existing firewall environment with a Cisco ASA 5510 and got a question regarding DMZ.I've currently set up like this:Ethernet0/0 (outside) - Public static IP AddressEthernet0/1 (inside) - LAN, internal ip addresses. Ever...
Hi Jennifer,thanks for your reply. I solved the problem myself, it seems that the tests give much better results if the remote workstation actually have an active connection to the internet . Everything is well, thanks again.Best regards,Andreas
I want to know if i need to set up nat for the dmz when i use "external" ip addresses on the dmz.The DMZ interface have machines connected like 193.17.67.* they're not supposed to be nat, just put behind the firewall and have acl lists applied to the...
