Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I use two L3 switches for connecting two sites on MPLS. Each switch has a GE port configured as routed interface connecting to a CE from the provider. OSPF routing appears to be working. Endpoint computers of one location can see those of the othe...
I work for a small business with only two locations, main and branch. We are in the midst of setting up MPLS connection to link them together. As requested by the carrier, we provided two pairs of /30 addresses to be used on the CE and PE equipment...
We are going to use Cisco layer 3 switches instead of WAN routers for connecting two locations via MPLS. To prepare for the installation, I set up a test environment to test the configuration of routed interfaces. I was able to get two endpoint lapto...
I am working with a software vendor to implement EDI for our ERP system. They installed the EDI software on a production server in the internal network (trusted zone). Two connections were configured in the EDI application: 1. Remote Host - connect t...
As indicated in the drawing below, we are currently connecting 2 locations on MPLS. There is a Cisco 800 series router serving as CPE in each location. The MPLS will be upgraded to 100 Mbps, which exceeds the capacity of the 800 router. Therefore,...
I will definitely raise the question with my provider. Other than the nuisance of having to specify the source IP when PINGing site2 from the site1 switch, there is no connectivity or routing issues. Therefore, I have switched over to the new circu...
>>ip route 0.0.0.0 0.0.0.0 172.20.2.1 I have had a default route on these 2 switches before but later removed them for trouble-shooting. It did not make any difference whether this static router was there or not. I guess one of the MPLS router might...
I did a show ip route [target] to find out the outgoing interface. It was defaulted to the routed interface connected to the CE router. To be able to ping the target, I had to specify the VLAN1 as the source IP on 3750. The 3650 switch in Site 2 a...
See below for the full config and sh ip route results. Site 1 - ConfigUsing 1642 out of 524288 bytes!version 12.2no service padservice timestamps debug uptimeservice timestamps log uptimeno service password-encryption!hostname Site1!boot-start-marker...
