Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
here's my setup:http://forums.smallnetbuilder.com/showthread.php?t=4674basically I want to hang my existing US Robotics router off an RV042 wired routerI want <b>one</b> subnet 10.117.xxx subnet mask 255.255.255.0 I see the RV042 (the lan side) will...
it works!first, on the US Robotics router I tried to set DHCP to disable and the IP to 10.117.xxx.250 but it didn't work becauseyou have click "apply".then I disconnected the US Robotics router from my iMac and from the cable modem and hooked up the ...
I think that I would rather have an RVS4000 because I'm never going to use two WAN ports on the RV042. I looked at Linksys BEFSX41 and I would just rather have better quality. However I don't think I'll ever use VPN.
okay I got it - leave the WAN port empty on the USRobotics routerdisable DHCP on the USRobotics but of course leave it on the Cisco routerokay next step is to actually buy the Cisco router which is going to take a few days All wireless devices will g...
thanks so much for replying Phillip!Sounds like you just want to use the USR as an access point and use no routing capabilities.that's exactly what I want to doI know, what if in the WAN options I specify IP and put 10.117.xxx.1 (the address of the L...
