Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everybody,My Router have one interface vlan1 connect to internal network, the other interface fe4 connect to ISP (Wan connection - fiber optics)I have "late collision error" on fe4 when use show interface fe4 command, but no collision when I detec...
ok, I will try to do it later 1more times. (now cannot because Im remoting to the router from outside, if I apply and the connection is down, I cannot access again As I said, yesterday I changed it to Full duplex but the connection was down immediate...
No, fe4 I configure as auto:interface FastEthernet4 description $ETH-LAN$ ip address X.X.X.38 255.255.255.252 ip nat outside ip virtual-reassembly duplex auto speed auto!
Here is for vlan1 interface (internal network):Vlan1 is up, line protocol is up Hardware is EtherSVI, address is 8843.e187.bf44 (bia 8843.e187.bf44) Description: $ETH-SW-LAUNCH$$INTF-INFO-HWIC 4ESW$ Internet address is 192.168.1.254/24 MTU 1500 b...
