Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
You can configure HSRP in networks that run which of the following protocols (Choose all that apply)?A. Banyan VINESB. IPC. IBM DLCD. Novell IPXE. AppleTalkAnswer: A, B, D, E I believe that HSRP is a cisco-proprietary, so my answer was "B" only.Why t...
Which one of the methods below, in Layer 3 switching, uses a forwarding information base (FIB)?A. Route cachingB. Demand-based switchingC. Flow-based switchingD. Topology-based switchingmy answer (according to the CCNP BCMSN for David Hucaby) Page 29...
helloyes , i believe that this switch is has the switchport command as a default.Check out thishttp://www.cisco.com/en/US/docs/switches/blades/3130/software/release/12.2_50_se/command/reference/cli3.html#wp2893231also check the IOS versionhttp://www....
you can use ACL (extended) , that you configure your ACL statement as follows:put your host as a destination address and put any incoming connection as source.hope that helpsregards,Amro
