Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi to all,I have two rservers (in this case they are firewalls) and they have to replicate active sessions to each other in case one of them is gone. But I am not able to configure both as a backup-rserver for each other. It says "Cannot assign backu...
Hi to all,Assume that inbound interface of FW1 side cable unplugged. In this scenario the probes are still up. Probes cannot detect this situation and fail over doesn't take place. As you can see it is impossible to detect cable tear down unless we h...
We are replacing CSS with ACE. --------------CSS_Config--------------service apps1 ip address 10.4.11.1 range 3 keepalive type http keepalive frequency 15 activeservice apps2 ip address 10.4.12.1 range 3 keepalive type http keepalive frequency...
Thank you for your answer. They are active/active. But the checkpoints we are talking are not using cluster XL for failover. They are using third party (ACE) for the fail over also. So ACE has to know about firewalls with probe. They don't have VIP I...
First of all, Thanks for your quick reply.I use CSStoACE conversion tool. And it says...The range option of the ip address subcommand under service configuration is not converted. Only the first ip address would be converted. For each of the remai...
