About cascon.com

cascon.com · 11-28-2012

Hello,we have a problem with the throughput over etherchannel in LACP with 2 or 4 ports.It is iSCSI traffic (vmware esxi 4.1 U3) is going from 2 separate NICs (ports) to the etherchannel (with 2 or 4 ports) that has a SAN connected (Nexenta).The SAN ...

cascon.com · 04-10-2019

The "unassigned" label under IP addresses when looking at show ip int brief designates that no IP address has been set for a specific port or a VLAN.

cascon.com · 11-30-2012

Glen,we do not have a single stream going on here. We have two NICs pumping iSCSI traffic from esxi server. We have RR policy and we can see the traffic splitting beautifully. Your comment is related to a single IP, single stream.Still thank you ...

cascon.com · 11-30-2012

leolaohoo,yes we know that nothing is wrong with the output.How do you explain the behavior of the traffic on the etherchannel by switching from passive to active on the SAN? It looks like the SAN has the issue then, right?Also, although we get full...

cascon.com · 11-29-2012

The output is below.We just figured out that it was LACP setting on the SAN aggregate was set to passive. As soon as we set to active, the traffic was load-balanced across the SAN ports on the switch, but still just to 1GBit/s (on the port Rx of the...

cascon.com · 11-29-2012

We have the same results with or without QoS. We think that looking into the table posted before, the Rx port on the SAN side (gi 0/42) is the port receiving data from the SAN.We will notify the SAN company to ask for some more information.

Member Since	‎11-28-2012 01:48 PM
Date Last Visited	‎04-10-2019 05:39 PM
Posts	9

User Statistics

User Activity

Throughput of etherchannel on 3560G

Re: Port VLAN assignment.

Re: Throughput of etherchannel on 3560G

Re: Throughput of etherchannel on 3560G

Re: Throughput of etherchannel on 3560G

Re: Throughput of etherchannel on 3560G