Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
I have one problem which I cannot bypass. Usually it works on physical interface out of the box, but this simply I cannot bypass. In short don't know how. I have configured one interface Gi1/8.10 VLAN 10 with IP 192.168.0.1 and management interf...
Hi, I am having one urgent issue to fix. I have set 2 subnets (WAN from ISP). WAN1 that is used for GuestWiFi, and WAN2 for TVServer.
GuestWiFi is set and working perfectly, but TVServer WAN is multiple public IP. What I've done is, set first IP on p...
Since I have never worked with ASA having a multiple WAN on same interface, how this can be achieved? My ISP has given me /29 IP address, and I assigned xxx.xxx.xxx.xxx/29 to one physical interface, set gw, route for gw, nat, access lists, etc. My qu...
Hi folks,
I have one huge issue regarding VPN which I cannot resolve or connect the dots (what can possibly cause an issue)
One of our customers wants to replace old snapgear with something better so they've choose ASA to do so.
I have created all th...
Hi to all of you
I am having an issue on my firewall, but since I am quite new in ASA I cannot find the cause.
I have found some similar issue regarding this, but it doesn't help me fix my problem:
I have set on the management port IP (in ASA IOS)...
Quite bizarre, it look like it start to work after couple of minutes, even though I haven't changed config. Also what I noticed for some reason each "DHCP server" on sub interface takes at least 3 minutes to start of releasing IP from the pool.
Hi Boris,
I must admit that I am bit confused here. If you initiate traffic from ServerTV through WAN_OLD it has translation of xxx.xxx.xxx.xxy and it is written in header of each packet. When it gets back, it is using same IP xxx.xxx.xxx.xxy as it i...
Yes, you are absolutely correct. It occurred me just few minutes ago that might be the route thing. (for that reason I opened new discussion on Cisco on this link mentioning two static routes with metrics... https://supportforums.cisco.com/discussion...
Hi Boris,
since nothing is currently connected to this server (there isn't device attached on that IP address on that port, is it possible to simulate that?).
I have set two different subnets (WAN). WAN1 for guestWiFi and default route metric 1 (dy...
Hi Boris,
I have set everything and it works (at least regarding port forwarding). The thing that I am missing is internet connection from inside to outside. Static NAT is set and I can get from outside (multiple WAN) to that server per specific port...
