Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear all,There is a problem with my Tandberg MXP:I received a error below when making a call:Attention:You can not place or receive calls.Network option is missing.Please install a network bandwith-option.I access to Software option to check. I see t...
Hi all,Could you help me for this case?I have the diagram as above. I want to configure the ASA: - If internal users access to abc.com, they will go through ISP1.- If internet users access to xyz.com, they will go through ISP2.How to do this???Thank ...
Dear Jens & MubashshirThank you for your help.I have already done as your instruction but it's still not working. I'm thinking about the network port of Tandberg. Normally, when I set IP address, subnet mark, default gateway and join the network, I c...
Dear JensThank you for your support.I followed your suggestion and recieved the information below from cisco:System Serial Number : 31A36761
Hardware Serial Number : 31A36761
MAC Address : 005060810559
Service Contract ...
