About dougy

dougy · 02-02-2017

Firstly, I have many years experience with unix servers but absolutely no knowledge, training, qualifications or expertise with Cisco. The present task involves configuring an 887, ideally using CCP. That 'should' be relatively straightforward as I ...

dougy · 02-03-2017

Once again the answer was found by googling and Cisco official sources proved completely useless. The Java runtime is absolutely critical. I did have the latest version but CCP will only work if the ancient 1.6.11 version is used and finding it isn't...

dougy · 02-03-2017

Found the following after a bit of googling Router(config)# ip http secure-server Router(config)# ip http authentication local It actually works and is infinitely more straightforward than the hopelessly complicated and misleading official informatio...

dougy · 02-03-2017

OK, that was a major breakthrough !!!!!! FastEthernet0 is now up up and I can ping the thing :) :) :) Next trick is to see if CCP is happy No such luck, but maybe its only a password issue Tried Router(config)#username admin privilege 15 passwor...

dougy · 02-03-2017

I gather that I stuffed up by not getting the FastEthernet ports up up. I assumed that getting Vlan1 up would fix the connectivity problem bit evidently not. It might take me a while to figure how to fix the FastEthernet config but I think I can do t...

dougy · 02-03-2017

FastEthernet0-3 are by default assigned to Vlan 1, you don't need to configure anything. To assign username 'admin' and password 'cisco' which then also can be used for CCP, do this: 887(config)#username admin privilege 15 password cisco If your DHCP...

Member Since	‎02-02-2017 02:37 PM
Date Last Visited	‎08-18-2017 03:56 AM
Posts	19

User Statistics

User Activity

basic configuration 887

Once again the answer was

Found the following after a

OK, that was a major

I gather that I stuffed up by

FastEthernet0-3 are by