Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm trying to setup catalyst switches to log to a syslog server. Some work and some don't work.
The commands I run are
logging host (Ip address)
logging traps informational
If I run send log 6 test that test event will show up in the syslog serve...
I figured it out, I didn't realize the syslog server was out of licenses for that type. Once I freed up some licenses I was able to add in ones that were previously failing. Weird though that creating a test log on the switch and the syslog would s...
They are catalyst 2960-x and are running the same IOS. I'm looking at doing a software update on them and see what that does. The version they are on is 15.0(2) EX5
Yes and that is correct. The line that didn’t work was me removing a logging host that I added just to generate an event. It wasn’t the actual server I’m sending them to.
Julio, I ran those commands and set the source-interface to the loopback and ...
Here are some lines that were created from me to generate some logs
Feb 6 14:29:13.969: %SYS-5-CONFIG_I: Configured from console by vty0 (x.x.x.x)Feb 6 14:32:17.735: %SYS-5-CONFIG_I: Configured from console by vty0 (x.x.x.x)Feb 6 14:32:18.735: %S...
This one is from a one that is working
Syslog logging: enabled (0 messages dropped, 46 messages rate-limited, 0 flushes, 0 overruns, xml disabled, filtering disabled)
No Active Message Discriminator.
No Inactive Message Discriminator.
Console lo...
