Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello!
I have recently inherited a network at at new job. The network consists of WLC 2500 (software version 7.6.120.0) with 5 AIR-CAP2702E-A-K9 AP (7.6.120.0) set in LAP mode and only 2 out of 5 APs work. What I have discovered is that if I power c...
Thanks for all the help with this guys! It looks like it was ports on the switch going bad. I moved the APs to different ports on the switch and they have been working great the past couple of days!
Thanks for the tips, Scott! I used canned air to blow out the AP PoE port and switch port. The cable tdr test results came out as "Good". So I am letting the AP point sit for 24 hours to see if stays up now.
Will report with results!
Here is a thought too. I am not sure the WAN controller is setup properly either. I have two connections going from the switch one is in a non-POE port and the other in a POE port. I am assuming this is for redundancy, but not sure.
Screenshot attac...
No items in the AP crash logs. In fact, the AP Crash Logs screen was blank with no messages there.
Do you have any tips on how to upgrade the firmware on the controller?
Here is the log file from performing the cable test. I am curious about a few things here.
Port 48 and Port 48 are connected to the APs that are currently working.
Port 45 and 46 are connected to APs that are not working. With the test results showi...
