About kennin.simmons

kennin.simmons · 01-04-2012

Hello,I am tasked with configuring a 2504 wireless controller. Is it possible to assign an SSID to an interface that has dynamic ap management enabled?Scenario:Location1:1) 10.0.0.0/242)192.168.0.0/24 DMZLocation 2:1) 10.0.5.0Both locations are rout...

kennin.simmons · 01-07-2012

I was able to get it working. Thanks for your help. I learned alot. I'm not sure what the bug was. But I had to have to interfaces with dynamic management enable. I was unable to wipe the unit and start from scratch since part of the config was ...

kennin.simmons · 01-05-2012

I think I have it configured. I have three interfacesmanagement 10.0.0.4 dynamic ap enabledmain network 10.0.0.6 dynamic ap enableddmz 192.168.0.4 Since adding the second interface with dynamic ap enabled, I am now able to assign an ssid to the...

kennin.simmons · 01-05-2012

I'm getting "IP information conflicts with another interface" when trying to configure port 3 on the same subnet as port 1I have dynamic ap management enabled on Port 1Vlan Tag 0 (untagged)IP: 10.0.0.4SM: 255.255.255.0GW:10.0.0.5Dynamic AP Management...

kennin.simmons · 01-05-2012

That's my issue. The access points do not communicate with the controller unless dynamic ap management is enabled. Once I enable dynamic management on an interface, I am unable to assign an ssid to that interface.

kennin.simmons · 01-05-2012

I only have 6 AP's. Is it possible to to implement a cisco wireless controller on 1 flat network? (1 subnet) If so, how?

Member Since	‎01-04-2012 01:13 PM
Date Last Visited	‎08-18-2017 03:51 AM
Posts	13

User Statistics

User Activity

Question about 2504 Wireless Controller

Question about 2504 Wireless Controller

Re: Question about 2504 Wireless Controller

Re: Question about 2504 Wireless Controller

Re: Question about 2504 Wireless Controller

Re: Question about 2504 Wireless Controller