Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,My goal is to limit individual voicemail message length to 1, 2, or 3 minutes maximum. For some reason, whenever an incoming call goes to voicemail, and the person hangs up, the call is not being disconnected. That said, I looked at the post ...
Wendy,Thanks for your feedback. I tried to implement the manual disconnect PMF using a variety of different disconnect tone sequences and I have not been successful with any of them. I will forward to you via email, an actual recording of the disco...
Further Information on the Disconnect Sequence:When the person hangs up the phone, the IP PBX hears the following from the CO:1) A short period of silence (Around three seconds)2) A very short tone that is similiar to when you are calling someone (Ar...
As a follow-up to my most recent post, I have been able to record the disconnect tone. Unfortunately, I am unable to attach the file here. That said, I have also done some initial analysis using Sigview Signal Analysis Software and I have been able...
Christopher,Thanks for the feedback. As per your comment, I did open a case with Cisco Small Business Support Center and I got a Case ID. In fact, I also submitted a case to the Certification and Communities on-line support team as well.That said, ...
Hello,Thanks for the feedback. I submitted a response via the method you suggested but I must admit that I completely forgot to include your contact email in the post, I hope you would be able to find the post. That said, I installed the unit down ...
