Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Upgraded 5508 WLC from 7.0 to 8.0 and now the OEAP600 will not join. The message reads, "Unknown AP type. Using Controller Version!!!". Does anyone know if the OEAP 600 is compatible with 8.0.120?
We use Intermec hand held devices, model CK31, for inventory. We are converting our wireless sites from "autonomous" access points to LWAPP access points in conjunction with WLCMs. I have noticed a significant drop in signal coverage going from aut...
Has any had success with configuring a WLCM to use secure NTP? I have a WLCM running with software version 7.0.230.0 that appears to be working, butbut when I check the status in the CLI, shows up as AUTH FAILURE.
Scott, I checked the settings. It was set to the defaults 30 and -10, but I previously manually changed the power setting (max power) on an access point that the Intermec device was connected to and it had no affect.
