Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Campus LAN (not too big) with a pair of CP/BN (for the entire campus)
Several buildings with Dist switches (Intermediate nodes) and Fabric Edge (FE) nodes.
LAN Automation will be building by building, or single building at a time in 2 passes - first ...
How to migrate from 2 nodes co-located CP/BN on an SDA site to 2 dedicated CPs and 2 dedicated BNs?
For instance, following the SDA CVD if I start with a small site model for a given site/fabric with CP/BN co-located, how can I later migrate to a med...
ISE cube of 2 nodes in HA.Need to change the DNS domain.This will make the certificates(from CA) invalid.Will this break the sync between ISE node A and node B?Will this lead to restart of the most of the services?I am aware the EAP AuthC will stop, ...
In the Catalyst Center 2.3.5.5 Inventory C1127 router is indicated as unsupported device. In the compatibility matrix C1127X is mentioned as being supported. As far as I know the only difference between C1127 and C1127X models is the ammount of onbo...
Let us consider a Catalyst Center in the DC and a number of small remote sites, where each site has a router and a FIAB switch. Can we use PnP for setup the router and the FIAB switch or the only option is to manually configure the router and then to...
Can the PnP be used for unsupported device type? For example C1127 router with IOS XE 17.9.4a is indicated as unsupported device type in Catalyst Center 2.3.5.5. What limitations will be hit? Will this router be supported ever?
Thanks, that still is my plan, if I need to.
The point here is to receive some guideline from Cisco TME or TAC SE if that has been done before.
Also, is there a good reason for doing it?
According to Scott Hodgdon (@Cisco) more than 95% of all the de...
