Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
I have the following scenario: A CUBE is used to route calls from A to B. A monitors the connection to the CUBE with SIP Option Pings, as well as the CUBE monitors the connection to B. If the connection between the CUBE and B is broken (for insta...
Hi,
sounds interesting. When does CUCM then start to use the faulty CUBE again?
And which scripts did you use? SIP Normalization on the CUCM, TCL on the CUBE ...?
Kind regards,
Benedikt Schmidt
Actually I have simplified the scenario a little bit, because A and B consist of two servers, therefore we have in total 4 dial-peers. But this should also be possible, as if-statements seem to be supported (https://supportforums.cisco.com/discussion...
