Hi All,Greeting!I'm trying to test out the CoPP violation on C9600 switch.By this guide, https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9600/softwasimire/release/16-11/configuration_guide/sec/b_1611_sec_9600_cg/b_1611_sec_9600_cg_chapter_...
I got conformed packet hits on system-cpp-police-data. I made the C9600 to generate the ICMP destination host unreachable.On a device, I set c9600 IP as gateway. ping from a device to unreachable host so as to get C9600 to generate the ICMP destinati...
@MHM Cisco World sorry for my delay response. I was a bit under weather for some days.actually. actions: drop has been configured by default. my previous output was taken by filter. Here is complete default config. C9606R_CS01(config-pmap-c-police)#d...
I did ping repeat 100000. No dropping on ping as well as no hitting on class. And I wonder how to ping or how to make to hit the class, at least to see conformed bytes.
@balaji.bandi I've found that document and read through it. As far as I understand, it is implementing own ACLs class-maps along with policy map and set it onto CoPP. In this case, I realized it will obviously hit the exceeded as long as I set minimu...
@MHM Cisco World ICMP traffic cpu queue is related to class system-cpp- police-data.default parameter as follows;class system-cpp-police-datapolice rate 750 ppswhen I assign it to 10 pps, the min pps allowed to set for this value is 250 pps. Then whi...
