Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to configure dial backup between two Cisco routers. When the remote router dials into the central router, you can hear the central router answer, but it does not begin the handshake until two or three seconds pass. During this time, the r...
I am trying to configure dial backup on a WAN router so that when the WAN interface goes down, the router will initiate a dial back up using a modem connected to a serial interface off of this router. Here is part of the config. When the WAN interfac...
Juan,Ok, getting closer... I removed the chat script backup from line Aux 0 and now I am able to connect to the head-end router but now I do not seem to be authenticating. I have made sure the usernames are created on both routers and I reset the pas...
JuanThank you for the reply. I am using a US Robotics modem(not sure of the model now)....I will do he debugs Friday morning and post them. I will also remove the chat script then also.You are wanting to see the above debugs from the National router,...
Here is the relevant config for the headend router:version 12.4no service padservice tcp-keepalives-inservice tcp-keepalives-outservice timestamps debug datetime msec localtime show-timezoneservice timestamps log datetime msec localtime show-timezone...
Here are the debug outputs you requested. When the remote router dials out and connects to the headend router, you can hear the headend router answer, but it seems to take too long to begin negotiating and the remote router just disconnects. You can ...
