About rade3023

rade3023 · 03-06-2017

I've tried multiple times to create a thread with an explanation of my problem and everytime I'm getting a message saying that it triggered a spam filter and then when I reported it to the company managing it nothing happens. This is as much a test...

rade3023 · 03-10-2017

I can ping 128.138.221.1 successfully, I tried adding the static route as you suggested but still no internet access.

rade3023 · 03-09-2017

Below is the output of those commands. One other potential problem: I contacted the IT department of the university and they said that all new routers must be whitelisted by MAC address. This router has no sticker on the bottom with a MAC address, I ...

rade3023 · 03-07-2017

Well, still no luck. I made the changes you suggested, and it has the exact same problem. It will assign IP address to all the computers connected to it in the 192.168.1.x network, but none of those computers can access the internet. I also can't pin...

rade3023 · 03-07-2017

So say there's a server with a static local ip of 192.168.1.10, and I want to be able to access it from anywhere within the campus network, would the commands be: ip nat inside source static tcp 192.168.1.10 5000 interface Gi8 5000

rade3023 · 03-07-2017

Ah I see, was that a valid command at any point in time? Perhaps only for different models or something, because it seems like I got the destination being "any" from a tutorial. Also, I edited my other comment as you replied I think. About the portf...

Member Since	‎03-01-2017 08:07 PM
Date Last Visited	‎08-18-2017 03:56 AM
Posts	9

User Statistics

User Activity

Cisco 890 series Router Config Help

I can ping 128.138.221.1

Below is the output of those

Well, still no luck. I made

So say there's a server with

Ah I see, was that a valid