Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Our company uses a UC540W-BRI-K9 as a communications system with several SPA phones. The UC540 has software pack 8.1(planning to upgrade) and connected with ISDN lines. We configured it by CCA 3.0(1) and everything is working OK. The problem is th...
Our company has 2 sites (central and branch). We use 2 UC540W-BRI-K9 as a communications system, one at each site with several SPA phones. Both UCs have latest software packs (8.1) and connected with ISDN lines. We configured them by CCA 3.0(1) an...
Hi David, thanks for the reply.I did modify the subnet of the data vlan and it worked after all...The only difference was that i used CCA 3.1(1) instead of 3.0.(1). Probably that was a coincidence, I don't know... The webinars look very interesting,...
Hello Steve,we knew about the SR520-T1 but unfortunatelly in Greece (where our company is located) T1 lines are not provided.Thank you very much for your comments, you have been very helpful.
Hi Steve,thank you very much for helping us out, we have a much clearer picture now. The conclusion is that we must give up trying to configure the RV042s. We don't want to use the UC540s as head end routers mostly for maintenance reasons (we don'...
