Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
dear all,i know that cdp just shows only the directly connected but i have the case in which the show cdp neighbor command show devices that are not connected directly but through the 3com switch so what is the problem??
Dear all, i have a problem on ciscoworks lms2.6, suddenly i have a linke between two cisco switches one of them is 2950G and the other is 3560, the link has an attribute of D8 interface?? what does this mean??? there is no physical linke between thes...
Dear all,i have a meteroethernet network with fiber optic as my media, some times we have fiber cuts so, the switch which is a layer 2 become unreachable,also sometime we have switches turned off from power supply, so how can i generate a report or g...
deartry to use the object-group command, like the follwoingciscoasa(config)# object-group network MYNETWORKciscoasa(config-network)#network-object 192.168.0.0 255.255.0.0access-list us_HQ permit ip 192.168.53.0 255.255.255.0 MYNETWORKRegards,
Dear Jermie,I think the order of the actions is as the below:1. Encryption2. Routing3. NaTThe incoming traffic will be matched agains the VPN ACL first, if it matches then the packet will be in the vpn process.if the packet does not match, the routin...
