Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have four Cisco 2960-switches that I am going to configure Spanning Tree with. The topology looks like the picture I attach.My question is how I can verify that I have configured it correctly. I need to know what ports are supposed to be Blockin...
Hi,I attach my topology, so please have look at it while you read my quest.I need to know how to make my cisco-router01 as secure as possible on the "outside"-interface and still allow all traffic through the tunnel. Is there anyone who has some advi...
Thanks guys, those commands will help me! I just need to make sure that the correct ports are forwarding. On my Root Bridge (Switch0) all of the Trunk-ports are forwarding. Should it be like that?
Thank you very much for your answer!My VPN-tunnel goes from a virtual "tunnel-interface" (interface Tunnel1). Is it possible to put one acl on the "outside"-interface and another in the "tunnel"-interface. Or will the tunnel-interface get affected by...
