Looking for some help with requesting a Verisign cert via ASDM for SVC SSL vpn clients. Also, the FQDN is different internally than its DNS name used to connect. I saw the thread using the CLI but I'm much better with the GUI. Thanks in advance.
I have my 5510 on my DMZ but am not able to access it. I've checked the firewall rules and am allowing https traffic to that address. Other systems on my DMZ are able to accept https requests, but not the ASA. Any ideas? Do most people place the ...
I'm having trouble getting an ACL set. I'm trying to limit 1 particular system on 1 vlan to only being able to access 1 system on a different vlan. Can someone help me with the syntax to get this straight? Thanks.Ex: system 1: 10.10.3.5 should o...
Thanks for your help, and there are no hard feelings. I was confident that my initial post, which included an example of what I wanted, coupled with the posting of my configuration would suffice. I stated that I wanted to limit traffic FROM the 3.5...
My objective was to allow the 3.5 machine to ONLY communicate with the 0.102 machine, but it's still able to ping other machines on all vlans. Secondly, I need any machine to be able to access the 3.5 machine - I was only trying to limit traffic com...
Thanks for your patience with this. I was able to apply the ACL to the interface (see below), however, when I do it inbound, I can no longer connect to 192.168.3.5 but the 3.5 machine can get anywhere. When I changed the access group to out, I coul...
Thanks. This is the config from the 3550 where I created the ACL. I couldn't tunnel down to apply the ACL on the interface itself- only in general global config mode. Thanks for the help.clock timezone EST -5ip subnet-zeroip routing!ip domain-name...