Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
If you intend to use stackwise, you will need to use LACP.I would leave one 3750 "unstacked" and use enhanced pagp for dual active detection. This will reduce dual active detection times dramatically at the cost of managing an extra device. Note... ...
You can configure Etherchannel/PAgP from the blade switch to a VSS system**2 6500s with a VSL link between them The blade server switch would think it was connected to a single device. Here is a nice whitepaper:http://www.cisco.com/en/US/prod/collate...
It depends on how strong this person is and where in the rack they are installing the switches... Each chassis by itself will weigh 55 lbs. If you have a loaded unit, they can weigh up to 135 lbs. Now by racking, I am assuming you are not configuring...
Go with the 6500 with the Sup32. Cisco has a bundle with a chassis, Sup32, and a Fan for the reduced price. Few reasons the Sup32 is a better choice.. (engage your Local Cisco account team for a overview to compare architectures)Same Layer2 engine as...
Remember you will not see a match until the router is experiencing congestion. Queuing is a technique used in internetwork devices such as routers or switches during periods of congestion. So unless you experience congestion, you do not queue.for yo...
