Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Information sought.
Does the Cisco C1100TG-1N32A (Terminal Gateway Router) support the C-NIM-2T (Cisco 2-port 100-Mbps/1-Gbps dual-mode GE/SFP, Network Interface Module) module ?
Kind Regards
I am wanting to filter routes from BGP to OSPF based on the BGP community: Have the following setup: community-set GLF_Local_910 910:910end-setroute-policy BGP-To-CMN if community matches-any GLF_Local_910 then pass else drop endifend-polic...
Under Cisco IOS I have the following: route-map RPA-SET-MED permit 10match ip address prefix-list RPA-HTC-DMZ-NETWORKSset metric 50set community 4771:120!route-map RPA-SET-MED permit 20set metric 300 Under IOS XR for an equivalent route-policy as per...
How many vrf's does the ASR 9901 fixed chassis support, or is there licensing required.Was delivered 2 ASR 9901 routers with some S-A9K-9901-VRF-LC smart licensing, but have not been able to determine whether I actually need these licenses to impleme...
Thank you for that - I actually saw that thread however: Mention is made of the below as a solution: "You could set a tag based on the community using a table-policy under the proper address-family and then use this tag to conditionally redistributed...
I now have a permanent enterprise license to be installed in flash and to envoke using the appropriate "license install bootflash:xxxxxxxx.lic" command, would I need to reboot/reload the switch to apply the permanent license, noting it is already run...
