Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I recently obtained a 2851 and have been battling this issue for a week now. An odd set of circumstances happen with the bootstrap startup process. If the router has loss of power or when reloaded; it fails to read the CF card and boots to rommon. I ...
OP here, I've just gotten used to doing an ios tftp every time I turn the router on from rommon. I try not to powercycle the router while doing labs but I've not found anything that fixed mine.As mentioned above, as soon as I tftp the IOS over it aut...
Yes, I have tried different types of CF and USB with the same result. I have "official" cisco 256mb cf and a sandisk cf. I have tried various brands of usbflash.I added boot system statements to the config to cf, then usb0, then usb1 to see if perhap...
Just an update. Any rommon commands (dev, dir, etc) do not see cf or usb in either port. Using boot system flash & boot system usbflash0 didn't make a difference. I don't think this is resolvable via software fix, and assume this to be an issue with ...
