Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,We have several standalone APs (Cisco 1131) connected to some switches C3560/2960 switches. Three of the APs we cannot ping however we can see them when issuing the "show cdp .." command. Two other APs on the same 2960 switch are working fine with...
Hi,We have a WLC4400 controller with about 30 LAP. We moving to a new IP scope and was wondering what is the best way to change the IP address of the controller. We have tried doing this via GUI however we have to power cycle the controller to get it...
Switchport is in forwarding statespanning-tree bpdufilter enable didnt make a differenceshut / no shut didnt make a differenceRestarting switch didn't make a differentIOS 12.4 (10b) JAAny more ideas?
Thanks for the reply. Just been reading the configuration guide and it appears as you have mentioned that I have missed out the vlan-id. It does make sense.On another note what is the best way to find out how the existing LAP locates the controlller?...
