Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have six access points on my 2960 24ps. The other day four of these went down. These four all get power from the switch, the other two do not (they are still up). Looking at the switch, I am unable to see the access points connected with cdp neighb...
Ok, so I reset the new AP and configured the IP, Gateway and primary controller IP.
I now get the error %LWAPP-3-FALLBACK_DHCP: Invalid Static Gateway, so fallback to DHCP.
Yep, that's exactly what I tried next. I swapped the cable - still down.
I tried a new port - still down.
I directly connected the AP to the switch - still down.
I then tested my spare AP on the same switch port with the same cable and both the port ...
The switch can ping the WLC, but it cannot ping the AP. It does not see it connected. The port is dark and the interface is down down. Even with the AP directly connected to the switch port it is dark but the AP powers up just fine.
Here is the config for the switch port that the AP is connected to:
interface GigabitEthernet0/22 description To ... switchport access vlan 70 switchport mode access srr-queue bandwidth share 1 95 2 1 srr-queue bandwidth shape 100 0 0 0 storm-control...
When attempting to ping the WLC from the AP I get the output "% Unrecognized host or address, or protocol not running."
capwap ap ip address x.x.x.x x.x.x.x
"You should configure Domain and Name Server from controller CLI/GUI."
After all previous co...
