Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have set up an 1131 AP for OEAP. Everything is configured coeectly on the Controller, AP, and firewall. I take the AP home and connect it to my network. The AP connects to the controller as expected and broadcasts the WLAN's.So that all appears ...
Long story short, we are having a problem with someone call 911 and hanging up. I have our VoIP gateway (2821) set up inside of MARS (v6). I can see when someone dials 911 (%ISDN-6-CONNECT: Interface Serial0/2/0:22 is now connected to 911 N/A) but ...
I had a similiar issue when I first set my OEAP up.1. On the NAT config...this is a known bug. With NAT enabled, if any of your internal AP's need to reconnect to the controller, they will not be able to. Be sure to enable/disable NAT only when you...
There was a version of WCS where they changed how the accounts were visible. I do believe there was a bug in it. I'm just going off of memory of us having a similiar issue and that version is a few rev's old. I would recommend upgrading to the new...
Disabling DHCP Address required didn't help. I have tried searching the logs on both the controller and the ap but there is nothing after the ap successfully connects to the controller.
DHCP is configured on my home router. i don't have any problems getting addresses on my home wireless/network. The 1131 even receives one of my private IP's.I do have DHCP set to required on the WLAN. But that has not been a problem for any of the...
