Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Interface Dot11Radio0, Deauthenticating Station 000b.fdd6.1108 Reason: Previous authentication no longer valid I have an enduser that keeps dropping connection. I see in the logs of the 1120 AP the statement listed above. I have many other users off...
I have a simple deployment of two 1100 series AP that is providing wireless connectivity to end users so they can have DSL. The network is running fine UNTIL I activated the MAC address Filter that I had built. I had a few end users that could not ...
I have a user that is running windows me. I installed a 350 series wireless PCI NIC and it will connected and then disconnect for the AP. I have changed out the NIC, changed PCI slots, updated drives, ACU and firmware on the NIC, but nothing helps....
I have few 350 series clients that are working with 1100 series AP that keep dropping connections then re-connecting. Some of the PC are running XP and other Win 98. It is not the AP because I have other users that ate connected and have not issues...
I have just gotten a Laptop with windows 2000 and have tryied to install a 350 client card. I keep getting "Network Cable Disconnected" message. I have tried everything. I have also tried to install a 340 card and I have the same issues. I have n...
Thanks for the information, but we have the issue figured out. I have one client that is running Win 98 First Edition that causes issues when the radio is turned on. If I shut that radio off and power cycle the AP the network map is enabled and I c...
The problem has been resolved. I needed to update the BIOS. There was an issue with the PCI Card Bus and the NIC Card. Once IT update the BIOS the problem went away. Thanks to everyone that gave advice and help with this problem.Jim
Well I have loaded SP3 onto my Laptop and I still have the same issue. The NIC will auth and associate with the AP. I can see my MAC address in the association table, but it keeps coming up with Network Cable disconnected. I had another user insta...
I went in and tried to change the metric for the wired NIC and made sure that the wireless is set to 1, that did not help. I am just now downloading SP3 and going through the install. I will follow up with the status.Jim
