Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear sir,I now use Cisco 6509 & 5509. Sometimes, I found that apply the direction of acl at vlan does not make sense.e.g.I have an interface, vlan (with HSRP) as follows:=======================================int fast9/10 switch access vlan 34int vla...
Hi,I have tried the ACS 3.1(1). When I use IE5.5 with Windows 2000 prof (setting Traditional Chinese as default language) for remote admin, the NAR input options become gray in color and cannot input settings. Does ACS3.1(1) support Windows 2000 prof...
Hi,I encountered two types of atm configuration as follows:1. atm pvc 1 1 51 aal5snap2. pvc ABC 2/51 ubr 1000 encapsulation aal5snapIs config 1 applied QoS like cbr or ubr ? Is it no max bandwidth limited at this config ? Some one said that ...
Hi,I have two Ciso switches (but different IOS version 12.0 & 12.1). I want to connect them by EtherChannel. However, the command setting is difference as follows:In 12.1, the setting is as follows:int port channel 1 switch mode trunkint fast 0/24 ...
Hi,Our vendor told me that Realsecure 6.5 could not capture the traffic if it connected to switch with IOS 12.1. He explained that since 12.1 adds the vlan tag to the packet, realscure 6.5 cannot catch the packet. Is it 12.1 adding the tag ??? Please...
When I tried the setting, I found that port channel was not work. Instead, the spanning tree protocol was used.Both are Cisco2950C while one IOS is 12.1(6)EAC and another is 12.0(5.3)WC1.Are those EtherChannel commands compatible ?
I think it's compatible. However, sometimes I found that Cisco autonegotiation with some 10/100M network card would choose 10M and half-duplex. If so, set the Cisco port with 100M and full-duplex instead of autonegotiation.
