Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I have a question regarding server-failover when using rserver+backup-rserver or serverfarm+backup-serverfarm (via sticky).My understanding is, that in case a server fails, the existing connections will not fail over to a backup-server.We are loo...
I have redundant Nexus 7010, with several Nexus 2248 (Fex) attached.The N2k's are already attached and running and I just started the port configuration of the N2k's.When I tried to configure a port-channel on a Fex-port, it didn't go through and I g...
Is is possible to use the VRRP-MIB (1.3.6.1.2.1.68) to monitor the (VRRP) redundancy state of a CSS? The CSS Administration Guide only mentiones 1.3.6.1.4.1.9.9.368 (Cisco branch) for this.
Ok, I've just been informed by our Cisco SE, that port-channels aren't supported on N2ks, connected to N7ks, yet.Apparently, this will be supported with the upcoming v5.2.
each FEX is connected redundantly to a single N7k, the switch-redundancy for the servers comes from a second FEX in each rack, that connects to the other N7k.I'v already been searching for any clues/documentation regarding this and didn't have any lu...
Thanks for the answer, but are you sure, those are the correct links? Both cover CSS-redundacy-configuration, but don't seem to have anything to do with my question ?!?
