Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I've run in to a problem i cant figure out. Its a live environment and I must be careful not to make things worse, things are working mostly.... I have a link between 2 switches, trunk - dot1q, on one end everything looks fine on the opposite end...
The problem has been resolved it was a vtp prunning issue - the solution was to issue a "clear vtp prune-eligible (vlans)" on the upstream switch.Everything has been working fine since.
The problem has been resolved it was a vtp prunning issue - the solution was to issue a "clear vtp prune-eligible (vlans)" on the upstream switch.Everything has been working fine since.
Sorry my bad. I wasn't clear - 6509 is client and 2950 is transparent -2950show vtp statusVTP Version : 2Configuration Revision : 0Maximum VLANs supported locally : 250Number of existing VLANs : 19VTP Operating Mod...
Sorry I should have posted this at the begining:show int fa0/26 trunkPort Mode Encapsulation Status Native vlanFa0/26 on 802.1q trunking 1Port Vlans allowed on trunkFa0/26 1,34,157,166,172,...
This is the down stream switch, where everything looks fine. - Version 12.1(22)EA12, 2950interface FastEthernet0/26 switchport trunk allowed vlan 1,34,157,166,172,175,178,190,194,504,637,652,804 switchport trunk allowed vlan add 805,864 switchport mo...
