Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
After upgrading ACE module from A2(3.1) to A2(3.2) we started getting complaints about the ablity to upload a file in one of our applications. We are able to recreate the problem and noticed that when there is a failure, the ACE sends a TCP RST in bo...
I have two 6513s with an 802.1q trunk connecting them. Each switch has redundant Sup720s running in Native mode, IOS ver 12.2(18)SXF (they were initially running SXD3). A FWSM (ver 2.3(3), routed mode, single context) is in each switch, setup in fail...
I have two 6513s with an 802.1q trunk connecting them. Each switch has redundant Sup720s running in Native mode, IOS ver 12.2(18)SXF (they were initially running SXD3). A FWSM (ver 2.3(3), routed mode, single context) is in each switch, setup in fail...
I have DistributedDirectors that use the AS hop count as a metric for deciding which ip address to give out for a dns query. I have entered the following commands in an attempt to pad the AS entries for a particular AS, but it appears to be ignored. ...
Thanks for the reply Joel. You are correct we were experincing the noted bug. We opened a TAC case and worked with Jim Sirstin to identify that this was our problem. We implemented the suggested work around and it solved the problem. Here is the deta...
Thanks to the question asked by pallette, I ran across this; Field Notice: FN - 61935 - Catalyst 6500 Series and 7600 Series Service Module Incompatibility With Distributed EtherChannel and Packet Re-Circulation which references bug CSCee10005. I hav...
I will have to get setup to record more data, but I do know the FWSM showed a ping request and a ping reply at the "inside" interface.I believe my problem is related to the IOS command "firewall multiple-vlan-interfaces" which I put in place to allow...
I have been having the same tcp connection timeout problems. It happens with several different PIX and FWSM units with different software versions. We have determined that it is a 90 second idle period that breaks the connection for the end user. The...
