About ingotitze

ingotitze · 01-10-2013

Hi everyone,it's probably just me but I have tried real hard to get a simple AnyConnect setup working in a lab environment on my ASA 5505 at home, without luck. When I connect with the AnyConnect client I get the error message "User not authorized fo...

ingotitze · 01-14-2013

Hi Jose,here is what I got now:ASA(config)# sh run | begin tunnel-grouptunnel-group DefaultWEBVPNGroup general-attributes address-pool VPNPool authorization-requiredand DAP debugging still the same:ASA(config)# DAP_TRACE: DAP_open: CDC45080DAP_TRACE:...

ingotitze · 01-11-2013

Hi Jose,OK, so I created a tunnel group and the config now has these lines in addition:ASA(config-tunnel-general)# sh run | begin tunnel-grouptunnel-group TunnelGroup1 type remote-accesstunnel-group TunnelGroup1 general-attributes address-pool VPNPoo...

ingotitze · 01-10-2013

Hi Jose,here it is:ASA(config)# debug dap tracedebug dap trace enabled at level 1ASA(config)# DAP_TRACE: DAP_open: CC07C2C0DAP_TRACE: Username: tom.tucker, aaa.cisco.grouppolicy = DfltGrpPolicyDAP_TRACE: Username: tom.tucker, aaa.cisco.username = tom...

ingotitze · 01-10-2013

Hi Jose,thanks for your quick reply. Yes, I get prompted for the credentials and after I type them in, the prompt screen closes and it just shows me the window with the URL and Connect button again. The error message is recorded under the Message His...

Member Since	‎01-10-2013 11:43 AM
Date Last Visited	‎08-18-2017 03:56 AM
Posts	5

User Statistics

User Activity

AnyConnect error " User not authorized for AnyConnect Client access, contact your administrator"

AnyConnect error " User not authorized for AnyConnect Client acc

AnyConnect error " User not authorized for AnyConnect Client acc

AnyConnect error " User not authorized for AnyConnect Client acc

AnyConnect error " User not authorized for AnyConnect Client acc