Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Matt this should be pretty simple to do. You said that your base wifi system is controller based with LWAPP AP's correct?Assuming you already have PEAP in your current operation, all you would need to do is take your Autonomous AP and make it a WGB. ...
Sorry had a busy few days and neglected to check the post.Well to test things out you could just issue the following command.echo -n "Controller 1: " && /usr/bin/snmpwalk -v3 -u SNMPV3 -l authPriv -a SHA -A yourpwhere -x DES -X yourpwhere 10.x.x.4 ...
Well it must be something in your config, as my e61I and e65 both work on our 1250's and the 1140's. Have you tried running debugs on the controller while the device is trying to join?
So you connect at 54Mbps.. then it will slowly drop to 1Mbps and disconnect and then reconnect? Typically any driver over 2007-2008 should work and as the 1505 is new you shouldn't have that issue. Then under the driver settings make sure it is set...
