Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have these USCe (UCS-E140S-M1/K9) modules installed in our 3945 ISR Routers.They come shipped installed with a custom ESXi Image Profile, or you can download it from VMWARE.ESXi-5.0.0-623860-custom-Cisco-2.0.1.6.iso Will we be able to upgrade thes...
We have one WAAS edge device which is not returning the proper results when entered in a browser. When we reloadthe WAAS device, while it is rebooting, it will return the proper results. We have cleared all of the caches that we knowof and all of our...
For now we have just updated the CIMC to 2.2 through the browser utility within the CIMC.We then loaded the ESXi-5.1.0-799733-custom.We really like the idea of these at our spoke sites, but it would be great if they were easier to use, setup, and upg...
Be wary of the firmware update. We used the HHU as advertised and it bricked the cimc. Status says "Service Module Has Failed" and it is in a reboot loop. TAC has not even tried to troubleshoot this, they are just sending a new one.....
This case is now solved, for now. We opened a TAC and there was something wrong with the policy that was applied that was affecting mutiple WAAS devices. We were unable to grab a trace while this issue was in failure.In summary, we have an "ALL WAAS"...
We have found the problem to occur on mutiple edge device, which all inherit the same policy from the WAAS central manager. These accelerators have been in place and working without issue and we have not introducednew changes into our DNS infrastruct...
