Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a Cisco ASA 5585-x running an older IOS. I went to upgrade the IOS and after a reload I ran the Show boot command and and it showed the New IOS but when I did the Show Version command it showed the old IOS version. I think this has to do with ...
I have a Cisco 1921 router that I am trying to program, but it is booting to USBFLASH0: and not FLASH0:How can I change the boot option so that it boots to where I want it to
I have tried that, did a reload and then a show run | include boot and it is showing the correct boot. But when I do a Show version the results show boot system usbflash0: filename
