Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am installing a Cisco 4250 IDS Sensor at a customer site and having difficulties with the boot up process.Problem: When booting IDS Sensor it looks as though it is going through the normal boot process until the following message displays on the sc...
Security SMEs,Needing some clarification here. I understand that outbound VPN Client access from behind the PIX w/ PAT can be done with fixup esp-ike command on ver 6.3. Is there any way possible to get this to work with multiple outbound VPN Client ...
Hello, my customer has a PIX 506E set up to terminate remote access VPN sessions and is also set up as a PPPoE client for an ADSL network. I am able to establish a VPN session and receive an IP address from the client pool. At this point, I start a p...
I have a strange site-to-site VPN scenario between two PIX firewalls.PC--PIX506---CORELAN----PIX515---Router-----FRCLOUD My customer has a PC (far left) that needs secure VPN access to the FR cloud. This PC is sitting behind the PIX 506 a...
Hi, I need a sanity check here. A customer of ours currently has a 3030 in place to terminate (no more than 500) Remote Access VPNs. They will be adding about 80 Site-to-Site VPNs over the next few months to this 3030. For full redundancy, they are l...
Thanks for the reply. I ended up using the IDS Recovery option, which reimaged the device. After that, it booted up to factory defaults and allowed me to log in and configured it.Interesting that you mentioned the problem with the inages on the sligh...
Thanks for the tips. I'm not sure I understand why there would need to be a static mapping from 10.1.1.0 to itself. Wouldn't it need to be statically mapped to an address on the subnet on the outside interface of the 515? Let's say a device in the FR...
Thanks for the info. I have been digging around a bit more and came across a doc discussing the Backup Lan-to-Lan feature. Now I'm wondering if this would be a better option. It states that you can configure Backup Lan-to-Lan & Load Balancing on the ...
I enabled the "Use IPSec over TCP (NAT/PAT/Firewall) TCP port 1000 and that solved my problem. This is the first time I have ran into this problem after doing a number of VPN Concentrator installs. I wonder if it is related to the software rev on th...
