Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear Team ,I have miss understanding on dot1x authentication manager so, if someone can help me to understand those scenarios :-•1- If I have port configured to authenticate through dot1x first and failover to MAB if dot1x is not successfully. I have...
Dear Team,I have faced an issue with dot1x mab authorization between cisco switch 3750 and ISE 1.1. I have cisco IP phone connected on port # gig1/0/1 to authenticated through MAB with cisco ISE--------------------------------------------------------...
Hi team,After some troubleshooting I have fixed the issue since I have some mistake on DACL configured on ISE so, after fixing everything are working fine.but still I have some concern. why do I need pre-ACL applied on dot1x interfaces and what's th...
hi gents, one more thing,- if I enable dot1x on the port without configure guest & restriction vlan so, what will happend when the authentication faild.?the port should be assigned to unauthorized state but to which vlan should be assigned ?- if I en...
hi jan ,I just creat L2 Vlan # 410 and assign it under the port as switchport voice vlan 410 . I only used this vlan under this port.I will post the entire switch configuration ASAP.RegardsBasel
hi gents,thanks for your help. I used the default authorization rule for cisco ip phones which was permit all ip traffic & assign the device traffic class = voice. I didn't do any modification for this rule. as I mentioned early I can see the traffic...
Hi jrabinow ,I disable the debuge and reload the switch but its the same. I can see the flow is match the authorization rule successfuly but its not downloaded on the switch port. since the switch is still ignore the profile-name cisco-ip-phone.is t...
