Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I'm stuck, here is what i need:host1: 192.168.1.1 service tcp/443>>>>> public ip 1.1.1.1 service tcp/443host1: 192.168.1.1 service tcp/80>>>>> public ip 1.1.1.1 service tcp/80host2: 192.168.1.2 service tcp/22 >>>>> public ip 1.1.1.1 service tcp/2...
Hey guys,Is there a way to setup a port channel interface on a Cisco ASA 5512-x to return packets on the interafce from which it received them? Instaed of the round robin load balancing it does?Thanks
Is there a way to point two physical fiber connections on an ASA 5512-x to one (sub)interface? So that both fiber connections use the same gateway ip address configured on the ASA?Thanks
Hello, I am trying to add 89,462+ access list rules to an ASA 5510 running 8.2(5). I have added all the rules to an object group and when I try to apply the access list to an interface it gives me the foolowing error:ERROR: Cannot add policy to rule ...
Hello,I want to connect a Catalyst 2960s-48FPS-L switch via SFP trancievers to an AT-9924SP switch. I have a Cisco GLC-FE-100FX tranciever in the Cisco and an AT-SPFX/2 100FX tranciever in the Allied Telesis.Here is my problem:RTS-SW4A-01#show int g...
It works!!!!!!! It's ALIIIIIIIIIIIIIIIIIIIVE!!!!!!! Finally! So I wanted to test the tranciever in other ports on the 2960s and in another switch as Jimmysands recommended. I moved the transciever to port gi 51 on the 2960s and rebooted the 9924s. B...
Robert, Check you GBICS (SFPs). You might also verify your fiber has light through both strands. If you have a GBIC mismatch or bad fiber it can cause it to transmit and not receive or vise versa. Thanks for the response. The fiber cable w...
Ryan,I change the 2960s to untag vlan 1. When the fiber is connected the couters on the 9924sp increase, both tranmit and receive. The 2960s however only increases it's output packets. Here are the output captures:2960sshow int gi 1/0/52GigabitEther...
Ryan, thanks for the offer. I could use the help.Here is the information you requested:Status of the link light on the 9924 port connected to the 2960? Blinking greenshow system: Switch System Status Time 15:13:41 Date 20-...
