Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Network Security Community, We have a new FPR-1010, without additional feature subscription. What are the options to license it when both Internet access and FMC are not available? We do have a Smart account though. Thanks for your advice and...
Hi Experts, After using Firepower for a while, I found myself having this question about how IPS and AMP are handling "returning" traffic (i.e. allowed connections)? Let's use a simple example. I am allowing "inside" zone to connect to "internet" z...
Hi all,
I am not sure if this has been discussed or not. I am looking for recommendations on how to move some new Firepower service modules, which run on various ASA 5500-X's and performing only monitoring, from their currently registered virtual ...
Thanks again Rob. Just to share with the community. I successfully obtained the PLR license and applied it to our firewall. I had to contact Cisco TAC to enable the use of PLR on our Smart Account. I mistakenly assumed it was already enabled.After ...
Hi Rob, Thank you for your advice. You are correct. I can use PLR and that is a solution. Just FYI - I tried to follow the PLR steps, and ran into an error after entering the request code into our Smart Account portal. I am working with Cisco TAC ...
Thanks Marvin! I will start reading the PDF If you don't mind, could you please elaborate a little bit about what you said "..otherwise subject to the full suite of other NGFW inspections."? I would like to know if I can use a different IPS and AMP ...
Just to share my experience and one note with you, about moving the classic licenses from one FMC to another.
It is very important, at least for us, to keep track of the actual associations of PAK's and managed devices. i.e. which managed device ha...
