Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I was running the cable-diagnostics tdr test and show command on a 3560e switch. It returned a pair status of failed. Does anyone know what that staus means? It does not show as a valid status in the Cisco documentation I have found so far. Any hep w...
I just upgraded my Cisco NAC from 4.6.1 to 4.7.2 so I could manage my 2975GS switches. My last TAC case stated that when 4.7 came out it would support the 2975GS model. However, I do not see the 2975GS as a managed model. Is that correct or is there ...
I have had issues with the router negotiating the correct speed/duplex when set to auto. I usually leave the switch uplink at auto, however this switch negotiated incorrectly. I did try reload the switch, but that had no effect. The original intent o...
The far end is a Cisco 2811 connecting on Fa0/1. Both side are hard code for 100Full. I had reset the counter after finding a duplex mismatch.0230_3560e_48_SW1#sh controllers ethernet-controller gi 0/48 Transmit GigabitEthernet0/48 R...
The switch and and router are about 20ft apart, Home run between cabinets and terminated on CAT5e patch panels. Also, the cable-diag is being done the on uplink port between the switch and router, which is running clean. 0230_3560e_48_SW1#sh int gi ...
