Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello All,We are trying to move all CheckPoint Firewalls away from using RADIUS for authentication. We have a mandate to migrate all CheckPoint Firewalls to use CISCO ACS (TACACS+) for authentication instead. I've managed to configure the CISCO ACS f...
I'm new to the ASA5505 ver8.4 platform, so need some assistance. I'm able to build my tunnel but unable to RDP nor ICMP back to the INTERNAL network. VPN Client IP: 192.168.200.200INTERNAL IP: 172.17.130.200my configuration is below:HOME-ASAFW02(c...
Hi Jouni,I appreciate & thank you for all your input. Great idea! I will definitely try your suggestions and the RDP captures. This would great to see exactly what is happening with the traffic. Will try this as soon as I get home.--Ohmar
Hi Harish,I appreciate & thank you for all your input. Yes, you are correct, there is only 1-way communication for some reason. From the Remote-VPN-client-side:: its only XMITTING traffic, NOT RCVG trafficOn the Internal-PC: its only RCVG traffi...
Getting this as well on my ASA:HOME-ASAFW02(config)# sho crypto ipsec sainterface: outside Crypto map tag: dynmap, seq num: 30, local addr: 68.45.17.105 local ident (addr/mask/prot/port): (0.0.0.0/0.0.0.0/0/0) remote ident (addr/mask/pr...
Hi Gents,I changed the config according to what Harish mentioned above. BUT still it did not work. no nat (inside,any) source static inside-network inside-network destination static obj_192.168.200.128 obj_192.168.200.128 nat (inside,outside) 1 sou...
Jouni,Yes, the VPN client and tunnel were initiated and built, while the packet trace was running. I wanted to see what the capture looked like and why I wasnt able to initiate the RDP and ICMP from the VPN client. Yes, there are NO problems on th...
