Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everybodyI am working on deploying dot1.x through our company. I am stuck on configuring Cisco Phones to go on a correct VLAN when host-mode multi-domain option is used. I tried it on two C2960 switches with two different images. No matter what I ...
Hi again I thinks there may be a problem in MAB processing. I noticed that the policy authorized the PC on the MAB profile (still need to figure out why).I changed the authorization order to dot1x mab and after that both devices are connected.Once ag...
One thing solved but it is still not working as it should. When only the phone is connected, everything looks OK. I can ping the phone without a problem. This is an improvement as I could not do this before. The moment I connect a PC to the phone, pi...
Jan, you are the man! This worked as a champ. Rookie mistake I guess. My mistake was that I assumed this would work on a switch level by CDP, without any ISE config required. And to be fair no documentation I found mentioned anything about this. Onc...
Hi JanThank you for your response.This test was run with only the phone connected to the switch.This is what I see on the ISE server:Steps 11001Received RADIUS Access-Request 11017RADIUS created a new session 11027Detected Host Lookup UseCase (Servic...
